Fibocom G510 - CBC, Battery Charger Connection

G5/G6-Family AT Commands User Manual Page
156
of
243
AT+MTSM=3,30,-10,40 // Set to out-off boundary (-10 to +40 Celsius) unsolicited
reports for every 30 seconds.
OK
+MTSM: -20 // Unsolicited current report out-off the Low boundary.
+MTSM: -12 // Unsolicited report out-off the Low boundary after 30 seconds.
+MTSM: 47 // Unsolicited report out-off the High boundary after Nx30 seconds
AT+MTSM? // Read the current setting.
+MTSM: 3,30,-10,40
OK
AT+MTSM=0 // Set to stop the unsolicited report.
OK
AT+MTSM? // Read the current setting.
+MTSM: 0
OK
10.1.3+CBC, Battery Charger Connection
This command enables a user to query the battery power level.
Command
Syntax
Response/Action
Read
+CBC
+CBC: <bcs>,<bcl>
OK
The following table shows the +CBC parameters.
<Parameter>
Description
<bcs>
Battery status values
0 Battery powered
1 Externally powered - not implemented in Module
Note: The Module input power source is connected via the battery pins only,
so it is always battery powered.
<bcl>
VBAT voltage value, A decimal value represents the returned digital value.
The input level multiplied by 1000.