Fibocom G510 - MIPCONF - Configure Internal TCP;IP Stack

AT Commands User Manual Page
215
of
243
13.1.13 +MIPCONF - Configure Internal TCP/IP Stack
This command allows configuring TCP stack parameters, such as re-transmissions number, upper and
bottoming limits of re-transmission timeout, close delay. It can be used to configure TCP socket
parameters before socket activation. Configuration values will be stored in Module until power circle.
This command must used under MIPCALL is enabled.
Command
Syntax
Response/Action
Remarks
Set
AT+MIPCONF=<socket_I
D>[[,<retr_num>][,<min_T
O>][,<max_TO>][,<max_c
lose_delay>]
[,<is_nack_ind_req>]]
OK
or:
+CME ERROR: <err>
The Set updates
TCP stack
configuration
parameters.
Read
+MIPCONF?
+MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
OK
The read
command
returns current
settings of TCP
stack
parameters.
Test
+MIPCONF=?
+MIPCONF:
(1-4),(1-12),(1-10),(10-600),(1-75),(0-2)
OK
The Test
command
returns the
possible
parameters