Fibocom G510 - MGAUTH, Set Type of Authentication

AT Commands User Manual Page
201
of
243
OK
AT+MIPCALL=1,"internet","User1 ","Pswd",2
OK
AT+MIPCALL?
+MIPCALL: 2
OK
+MIPCALL: 123.145.167.230
13.1.2+MGAUTH, Set type of authentication
This proprietary command allows to enter the type of authentication for a user -name (using a password)
for the specified PDP context.This command is used for internal protocol.
Command
Syntax
Response/Action
Set
+MGAUTH=<cid>,<auth>,<name>,<pw
d>
OK
or:
ERROR: <err>
Test
+MGAUTH=?
+MGAUTH: (list of supported
<cid>s),( list of supported
<auth>s),(max length of <name>),
max length of <pwd>
The following table shows the +MGAUTH parameters.
<Parameter>
Description
cid
Digit string which specifies a particular PDP context definition (See “+CGDCONT,
Define PDP Context”).
auth
Set type of authentication
0 Don,t need authentic
1 PAP
2 CHAP
name
User name in provider server (in quotation marks). Contact your service provider for
details.
pwd
Password for provider server (in quotation marks). Contact your service provider for
details.