Fibocom G510 - Page 200

AT Commands User Manual Page
200
of
243
The following table shows the +MIPCALL parameters.
<Parameter>
Description
operation
0 - disconnect a link
1 - establish GPRS link
<status>
0 Disconnect
1 Connected
2 Busy(disconnecting or connecting)
"APN"
APN of service provider (in quotation marks). Contact your service provider for
details.
"Phone Number"
Phone number of CSD service provider (in quotation marks). Contact your service
provider for details.
"User name"
User name in provider server (in quotation marks). Contact your service provider
for details.
"Password"
Password for provider server (in quotation marks). Contact your service provider
for details.
“auth”
Set type of authentication
0 Don,t need authentic
1 PAP
2 CHAP
Local IP-address
IP address given by server after PPP negotiation.
Note: The "User name" and the "Password" parameters can be up to 64 characters each. The "APN" /
"Phone number" parameters can be up to 50 characters each.
Example:
AT+MIPCALL=1,"internet","User1 ","Pswd" //Connecting the provider 'Orange' and getting
an IP
OK
+MIPCALL: 123.145.167.230
+MIPCALL: 1,123.145.167.230
AT+MIPCALL=0 //The terminal hangs up the link