Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
73
of
243
5.3.3 +COLP, Connected Line Identification Presentation
This command relates to the GSM supplementary service called COLP (Connected Line Identification
Presentation), which enables a calling subscriber to obtain the connected line identity (COL) of the called
party after setting up a mobile-originated call with the Module. For example, after setting up a
mobile-originated call to one number that is forwarded to another number, the calling party will see the
number of that third party.
When this command is enabled (and the called subscriber permits it), the following intermediate result
code is returned:
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]].
Note: This command is activated when COLP is supported by the network.
Command
Syntax
Response/Action
Remarks
Set
+COLP=[<n>]
OK
+CME ERROR:
<err>
The Set command enables/disables the
display of the COL at the TE on the Module.
The value set by this command is not
retained after a power cycle.
Read
+COLP?
+COLP: <n>,<m>
OK
The Read command displays the status of
<n>. It also initiates a query of the COLP
service provision status and displays <m>.
Test
+COLP=?
+COLP: (list of
supported <n>s)
OK
The Test command displays the supported
values of <n>.
The following table shows the +COLP parameters.
<Parameter>
Description
<n>
Sets/displays the result code presentation status of the Module.
0 Disable (default)
1 Enable
<m>
Displays the subscriber’s COLP service status in the network.
0 COLP not provisioned
1 COLP provisioned
2 Unknown (for example, no network, and so on)
<number>
Sets the phone number, using the format specified by <type>.
<type>
Sets the address octet type in integer format (refer to GSM 04.08 [8]

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English