Fibocom G510 - MIPCLOSE, Close a Socket

AT Commands User Manual Page
205
of
243
13.1.4+MIPCLOSE, Close a Socket
This command causes the Module to free the socket accumulating buffer and to close the socket.
Note: All data stored in the accumulating buffer will be lost.
Command
Syntax
Response/Action
Set
+MIPCLOSE=<Socket_ID
>[,<Mode>]
OK
+MIPCLOSE:
<Socket_ID>[,<number_of_acknowledged_bytes>],<close_
type>
or:
ERROR
Read
+MIPCLOSE?
+MIPCLOSE: [<socket_ID>]
OK
(for all ACTIVE sockets)
or:
+MIPCLOSE: 0
OK
(if no active sockets)
Test
+MIPCLOSE=?
+MIPCLOSE: (1-4),(0-2)
OK
The following table shows the +MIPCLOSE parameters.
<Parameter>
Description
<Socket_ID>
Unique number that identifies a connection.
Valid socket numbers - 1, 2, 3 and 4
<Mode>
This value only used for TCP connection.
0 -- Wait FIN ack from Server (default)
1 – Do not wait FIN response from server.
<number_of_acknowledged_bytes >
Total number of bytes that were acknowledged.
<close_type>
Connection close type: