Fibocom G510 - MIPNTP, Synchronize the Local Time Via NTP

AT Commands User Manual Page
229
of
243
13.1.21 +MIPNTP, Synchronize the local time via NTP
This command causes the Module to synchronize the local time from the NTP time server.
Command
Syntax
Response/Action
Set
+ MIPNTP=<Remote_IP>,
<Remote_Port>
OK
+MIPNTP: <Result>
or:
ERROR: <err>
Read
+MIPNTP?
+MIPNTP:
<Remote_IP>,<Remote_Port>
Test
+MIPNTP=?
+MIPNTP((list of supported<”Remote_IP”>s),
list of supported<Remote_Port>s)
The following table shows the +MIPNTP parameters.
<Parameter>
Description
Remote_IP
The address of the NTP time server which could be a dotted decimal IP or a
domain name.
Remote_Port
The port of the NTP time server.
Result
1:Successfully synchronize the local time;
0: Fail to synchronize to local time.
Example:
at+mipntp="202.120.2.101",123
OK
+MIPNTP: 1
at+cclk?
+CCLK: "13/09/27, 05:28:48 +00"
OK