Fibocom G510 - MCELL Indication

G5/G6-Family AT Commands User Manual Page
140
of
243
9 Neighbor 4 Cell Information screen
10 Neighbor 5 Cell Information screen
11 Neighbor 6 Cell Information screen
12 Neighbor Cells Summary screen
13 Re-selection screen
14 Hopping Information screen
15 PDP1 Context Information screen
16 PDP2 Context Information screen
17 PDP3 Context Information screen
18 PDP4 Context Information screen
19 Serving Cell paging parameters
20 Optional SYSINFOs
21 Serving and Neighbor Cells Information screen
22 Serving Cell Information screen
23 Neighbor Cells Information screen
24 The LAC and Cell ID of Serving and Neighbor Cells I
9.1.7 +MCELL Indication
After AT+MCELL command, the information about the Cellular Network will return back by this +MCELL
indication format few seconds later.
+MCELL: <screen_title><CR><LF><screen_info><CR><LF>
The following table shows the +MCELL parameters.
<Parameter>
Description
<screen_title>
The requested screen title is written on the first line of each screen.
<screen_info>
The requested screen information.
<screen title>
Description
<screen num>
Serving Idle/PI
Idle/Packet Idle mode; Serving Cell Information
screen.
1