Fibocom G510 - 5.1.12 +CCFC, Call Forwarding Number and Conditions

G5/G6-Family AT Commands User Manual Page
53
of
243
OK (...conversation...)
AT+CHLD=3 //Add the held call to the conversation
OK
(...MTPY conversation...)
AT+CHLD=22 //Split: Place the MO active call on hold, MT call remains active
OK
AT+CHLD=0 //Release the held call
OK
NO CARRIER
ath //Release the active call
NO CARRIER
OK
atd9311234567; //Originate a voice call
OK
OK
+CCWA: "055728386",129,1," ",0 //Waiting call alerts
AT+CHLD=1 //Release the active call, accept the waiting call
OK
NO CARRIER //Active 9311234567 was released
OK //Waiting 055728386 was answered
5.1.12+CCFC, Call Forwarding Number and Conditions
This command enables control of the call-forwarding supplementary service. Registration, erasure,
activation, deactivation, and status query are supported.
Command
Syntax
Response/Action
Remarks
Set
+CCFC=<reason>,
<mode>[,<number
>[,<type>[,<class>[
,<subaddr>[,<saty
pe>[,<time>]]]]]]
If the command succeeds:
+CCFC:
<status>,<class1>[,<number>,<type>[,
<subaddr>,<satype>[,<time>]]]
[<CR><LF>
+CCFC:
<status>,<class2>[,<number>,<type>[,
<subaddr>,<satype>[,<time>]]][...]]
+CCFC: (list of supported <reason>s)
The Set command
instructs the Module
which call forwarding
settings to request from
network. The Set
command, in query
mode, interrogates the
network about the
subscriber current call
forwarding status.
Test
+CCFC=?
+CCFC: <reason>
The Test command