Fibocom G510 - 4.3.1 +CMEE, Report Mobile Equipment Error

G5/G6-Family AT Commands User Manual Page
36
of
243
000
OK
ATS24=5
OK //The Module enter Sleep Mode at once
ATS24?
005
OK
(If there are no radio and UART activities, the Module will enter sleep mode in 5 seconds)
4.3 Error Handling Commands
4.3.1 +CMEE, Report Mobile Equipment Error
The Set command disables or enables the use of result code +CME ERROR: <err> as an indication of an
error relating to the functionality of the Module. When enabled, Module-related errors cause a +CME
ERROR: <err> final result code instead of the regular ERROR final result code. Usually, ERROR is
returned when the error is related to syntax, invalid parameters or terminal functionality.
For all Accessory AT commands besides SMS commands, the +CMEE set command disables or enables
the use of result code +CME ERROR: <err> as an indication of an error relating to the functionality of the
Module. When enabled, Module related errors cause a +CME ERROR: <err> final result code instead of
the regular ERROR result code.
For all SMS AT commands that are derived from GSM 07.05, the +CMEE Set command disables or
enables the use of result code +CMS ERROR: <err> as an indication of an error relating to the
functionality of the Module. When enabled, Module-related errors cause a +CMS ERROR: <err> final
result code instead of the regular ERROR final result.
Command
Syntax
Response/Action
Remarks
Set
AT+CMEE=[<n>]
OK
or:
+CME ERROR: <err>
The Set command enables or disables the
use of result code +CME ERROR: <err> as
an indication of an error relating to the
functionality of the Module.
Read
AT+CMEE?
+CMEE: <n>
OK
The Read command returns the current
setting format of the result code.
Test
AT+CMEE=?
+CMEE: (list of
supported <n>s)
OK
The Test command returns values
Supported by the terminal as a compound
value.