Fibocom G510 - 7.1.2 +CMGF, Message Format

G5/G6-Family AT Commands User Manual Page
84
of
243
The following table shows the +CPMS parameters.
<Parameter>
Description
<mem1>
Memory from which messages are read and deleted.
Supported values are: "SM".
The default value at power-up is "SM".
<mem2>
Memory to which writing operation is made.
Supported value is: "SM"
The default value at power-up is "SM".
<mem3>
Memory to which received SMS are stored (unless forwarded directly to
TE). Supported value is: "SM".
The default value at power-up is "SM".
"SM"
SIM message storage
Example:
AT+CPMS="SM"
+CPMS: 5,50,5,50,5,50
OK
AT+CPMS?
+CPMS: "SM",5,50,"SM",5,50,"SM",5,50
OK
7.1.2 +CMGF, Message Format
This command is a basic command. The Set command handles the selection of the message format used
with send, list, read and write commands, as well as the format of unsolicited result codes resulting from
message receipts. The Module supports both PDU mode (where entire TP data units are used) and text
mode (where the body of the message and its headers are given as separate parameters).
Command
Syntax
Response/Action
Remarks
Set
+CMGF=<
mode>
OK
or:
+CMS ERROR: <err>
The Set command sets the message
format to use.
Read
+CMGF?
+CMGF: <mode>
The Read command displays the
current message format.