G5/G6-Family AT Commands User Manual Page
Example:
atd44345678; //VOICE call (with semicolon)
OK
OK
atd44345678 //VOICE call (with semicolon)
OK
OK
5.1.2 D>, Direct Dialing from Phone Books
This command places a VOICE call on the current network by dialing directly from the Module phone
ļ ā+CME ERROR: not found" is returned when no match is found in an existing phone book.
ļ
FD phone book supports the (?) wild card character. Telephone numbers containing this character
cannot be dialed directly from the phone book.
ļ "+CME ERROR: Invalid index" is returned when entry <n> is out of the requested Phonebook range.
ļ
When SM phonebook is searched and the given entry value is of the ME phonebook, ME phonebook
will be searched as well (result code would be the same as if MT phonebook was searched).
The following table shows a detailed description for the D> commands.
Originates a call to a phone number with the corresponding alphanumeric
field
<alpha>.
T
he
Curre
nt
Phone
Book
(Set
by
+CPBS)
is
searc
hed
for
the
entry
that
begins
with
the
alphanum
eric
pattern
<alpha>.
Originates a call to a phone number in memory (phone book) mem and
stored in entry location <n>.
Originates a call to a phone number from entry location <n> in the Current
Phone Book (Set by +CPBS).
Note: Current used memory (phone book) set/read is done through the memory command
+CPBS=/+CPBS? respectively.
The following table shows the D> parameters.
String type value, which should be equal to an alphanumeric field in a phone
To Next Page
Loading...
Need help?
General