To Next Page

To Previous Page

G5/G6-Family AT Commands User Manual Page

143

243

at+MCELL=0,22

MCC:460,MNC:0,LAC:9339,Cell ID:03600,BSIC:27,(P)BCCH

ARFCN:76,RxLev:56,RxDbm:-54,C1:30,C2:30,TxPower:5,RxAccMin:6,(PD)TCH

ARFCN:INVALID_ARFCN,Timeslot:0,MAIO:0,HSN:0,Timing

Advance:255,RxQualFull:6,RxQualSub:6

at+MCELL=0,23

NCELL:1,MCC:460,MNC:0,LAC:9339,Cell ID:04361,BSIC:41,(P)BCCH

ARFCN:82,RxLev:32,RxDbm:-78,C1:17,C2:13

NCELL:2,MCC:460,MNC:0,LAC:9339,Cell ID:04362,BSIC:38,(P)BCCH

ARFCN:60,RxLev:9,RxDbm:-101,C1:-1,C2:-1

9.1.8 +MCI, Module Cell Information

This command returns neighbor cell information. The command returns ARFCN, BSIC and RX level of

serving and adjacent cells. In case Module is registered, adjacent cells are from registered PLMN. In case

Module is in Emergency Mode, adjacent cells are physical neighbors. BSIC is displayed only in case SCH

(Synchronization Channel) is decoded.

The parameter <enable_TA> determines whether <TA> will be reported by +MCI command. <TA> is

defined for serving cell only. This value will be displayed only in Dedicated mode. The command output is

<Filter>dependent. In case the command output should be filtered to include just cells of a specific GSM

band (one or more) the filter parameter should be set accordingly. The filtering will apply to the neighbor's

cells only – the serving cell info will always be returned.

Using the set command without a parameter will return output according to the currently set <Filter>

value.

Command

Syntax

Response/Action

Remarks

Set

Execute

AT+MCI=<Filter

>[,<enable_TA

or:

+CME ERROR: <err>

This command will return “OK”

only. The neighbor cell information

will return back with +MCI format

few seconds later.

Fibocom G510 User Manual

Other manuals for Fibocom G510