Fibocom G510 - Page 144

G5/G6-Family AT Commands User Manual Page
144
of
243
AT+MCI
Read
AT+MCI?
+MCI: <Filter>,
<enable_TA>
OK
The Read command returns the
current set <Filter> and
<enable_TA> values.
Test
AT+MCI=?
+MCI: (List of
supported <Filter>s),
(Range of supported
<enable TA>s)
OK
The Test command returns the
ranges of <Filter>'s supported
values and
<enable TA> supported values.
The following table shows the +MCI parameters.
<Parameter>
Description
<Filter>
The requested GSM band's ARFCNs. This is an integer which can be a
combination of all (1-15):
1 - GSM 850
2 - GSM 900
4 - GSM 1800
8 - GSM 1900
The default value is 15.
<enable TA>
This parameter defines whether <TA> will be reported by +MCI
command.
Defined values:
0 - Do not report <TA> value.
1 - Report <TA> value.
The default value is 0.