Fibocom G510 - MIPPUSH, Push Data into Protocol Stack

AT Commands User Manual Page
210
of
243
13.1.7+MIPPUSH, Push Data into Protocol Stack
This command causes the Module to push the data accumulated in its accumulating buffers into the
protocol stack. It is assumed that before using this command, some data should exist due to previous
+MIPSEND commands.
Command
Syntax
Response/Action
Remarks
Set
+MIPPUSH=<Sock
et_ID>[,<"Destinati
on_IP">,<Destinati
on_Port>]
+MIPPUSH:
<Socket_ID>,<Status
>[,<accumulated_se
nt_length>]
OK
or:
ERROR
Optional parameters are used only for
UDP connections. If the Destination IP
and Destination Port are not provided by
the user, a datagram is sent to the last
target (or the default target provided by
the +MIPOPEN command).
<accumulated_sent_length> - this
parameter counts how many bytes were
sent to the remote side by the Module
TCP/IP stack. When user open socket,
<accumulated_sent_length> initialized
to zero.
Size of <accumulated_sent_length> is
four octets unsigned digit
(0-4294967295).
<Status>:
0 - Success
1 - socket is flowed off
2 - there is no data in socket to send
Read
+MIPPUSH?
MIPPUSH:
[<socket_ID>]
OK
Test
+MIPPUSH=?
MIPPUSH=<socket_I
D>,<IP>,<Port>
OK