Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
183
of
243
11.2.11+ MMICG, Microphone Gain Value
This command handles the selection of microphone gain values of MIC-handsets and MIC-headsets. The
new value remains after power cycle.
Command
Syntax
Response/Action
Remarks
Set
+MMICG=<gai
n>
OK
or:
+CME ERROR: <err>
The Set command sets the
microphone gain value.
Read
+MMICG?
+MMICG: <gain>
OK
The Read command displays the
current microphone gain.
Test
+MMICG=?
+MMICG: (list of
supported <gain>s)
OK
The Test command displays the list
of supported gain values.
The following table shows the +MMICG parameters.
<Parameter>
Description
<gain>
Microphone gain values:
0-15 0 is lowest gain value (not mute); The default value is 8.
11.2.12 +MATONE，Start or stop the tone play,and the tone plays
only once
Command
Syntax
Response/Action
Set
+MATONE=<state>,<tone_i
d>,<mix_fac
tor>,<play_time>
OK
or:
+CME ERROR: <err>
Read
+MATONE?
+CME ERROR: <err>
Test
+MATONE=?
+ MATONE:
<state>,<tone_id>,<mix_factor>,<play_time>
OK

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English