Fibocom G510 - Page 184

G5/G6-Family AT Commands User Manual Page
184
of
243
The following table shows the +MATONE parameters.
<Parameter>
Description
<state>
0 : stop
When state=0,means the tone is stop
1 : start
<tone_id>
<tone_id> integer indicating the audio tone ID and may be:
0: aud_tone_DTMF_0
1: aud_tone_DTM F_1
2: aud_tone_DTMF_2
3: aud_tone_DTMF_3
4: aud_tone_DTMF_4
5: aud_tone_DTMF_5
6: aud_tone_DTMF_6
7: aud_tone_DTMF_7
8: aud_tone_DTMF_8
9: aud_tone_DTMF_9
10: aud_tone_DTM F_a
11: aud_tone_DTMF_b
12: aud_tone_DTMF_c
13: aud_tone_DTMF_d
14: aud_tone_DTMF_s;”*”
15: aud_tone_DTMF_p ;”#”
16: aud_tone_dial_tone
17: aud_tone_sv_subscriber_busy
18: aud_tone_sv_congestion
19: aud_tone_sv_radio_path_ack
20: aud_tone_info_call_dropped
21: aud_tone_special_info
22: aud_tone_sv_call_waiting
23: aud_tone_sv_call_ringing
24: aud_tone_info_test
< mix_factor>
<mix_factor> integer indicating the kind of volume for tone generation;
range 0 .. 7