Fibocom G510 - MSTART, Start Message Notification

G5/G6-Family AT Commands User Manual Page
38
of
243
4.4 +MSTART, Start message notification
This command can Enable/Disable module output start message when power up.
Command
Syntax
Response/Action
Set
+MSTART=<at start>,<sim ready>
OK
or:
ERROR
Read
+ MSTART?
+MSTART: <at start>,<sim ready>
OK
Test
+MSTART=?
+MSTART: (0-1,0-1)
OK
The following table shows the +MSTART parameters.
<Parameter>
Description
<at start>
0: Do not output “AT command ready” from UART
1: Output “AT command ready” from UART (default value)
<sim ready>
0: Do not output “+SIM READY” after SIM init OK
1: Output “+SIM READY” after SIM init OK (default value)
Example:
AT+MSTART=?
+MSTART: (0,1),(0,1)
OK
AT+MSTART=1,1
OK
AT+MSTART?
+MSTART: 1,1
OK