Fibocom G510 - CLCC, List Current Calls

G5/G6-Family AT Commands User Manual Page
62
of
243
The following table shows the +CPAS parameters.
<Parameter>
Description
<pas>
0 - Ready - The Module allows commands from the terminal
1 - unavailable(MT does not allow commands from TA/TE)
2 - Unknown - The Module is not guaranteed to respond to instructions
3 - Ringing (MT calls) - The Module is ready for commands from the terminal,
but the ringer is active
4 - Call in progress - The Module is ready for commands from the terminal, but a
call is in progress
5 – Asleep (MT is unable to process commands from TA/TE, because it is in a
low functionality state.
Example:
AT+CPAS
+CPAS: 0
OK
AT+CPAS=?
+CPAS: (0-5)
OK
AT+CPAS?
+CPAS: 4
OK
AT+CPAS//Voice call active state
+CPAS: 4
OK
5.2.2 +CLCC, List Current Calls
This command displays a list of all current Module calls and their statuses, and also enables/disables the
unsolicited indication of the call list. (If no calls are received, no information response is sent to the
terminal.)
If the command succeeds but no calls are available, no information response is sent to the terminal.
The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 on hold).
Command
Syntax
Response/Action
Remarks
Set
AT+CLCC=<state>
OK
The Set command enables/disables
unsolicited indications.