Fibocom G510 - 4.1.7 &F, Set to Factory Defined Configuration

G5/G6-Family AT Commands User Manual Page
27
of
243
...
(profile data)
OK
or
+CME ERROR: <err>
Example:
AT&V
ACTIVE PROFILE
&C1, &D1, &K3, E1, Q0, V1, X0, S0:0, S3:13, S4:10, S5:8, +CRC: 0
STORED PROFILE 0:
&C1, &D2, &K3, E1, Q0, V1, X0, S0:0, S3:13, S4:10, S5:8, +CRC:0
OK
4.1.7 &F, Set to Factory Defined Configuration
This command restores the factory default configuration profile. The Module only supports one factory
default profile, 0.
Command
Syntax
Response/Action
Remarks
Set
AT&F<value>
OK
or:
+CMS ERROR: <err>
Read
AT&F?
<current profile number>
Test
The Test command for &F is not
defined by ITU, and therefore is not
supported by the Module. The
Module returns an error.
The following table shows the &F parameters.
<Parameter>
Description
<value>
0 Factory default configuration profile. This is the only value supported.