Fibocom G510 - S96, Echo Canceling; CALM, Alert Sound Mode

G5/G6-Family AT Commands User Manual Page
177
of
243
Read
ATS94?
+S94:<n>
OK
The Read command returns the
sidetone status.
The following table shows the S94 parameters.
<Parameter>
Description
<n>
0-7 Sidetone range.
0 is lowest sidetone (not mute).
The default value is 004.
11.2.5S96, Echo Canceling
This command suppresses a large amount of the output sound picked up by the input device (cancels all
echo).
Command
Syntax
Response/Action
Remarks
Set
ATS96=<n>
OK
or:
+CME ERROR: <err>
The Set command sets the echo
canceling status.
Read
ATS96?
+S96:<n>
OK
The Read command returns the echo
canceling status.
The following table shows the S96 parameters.
<Parameter>
Description
<n>
0-7 echo canceling range.
0 is lowest echo canceling (not mute).
The default value is 004.
11.2.6+CALM, Alert Sound Mode
This command handles the selection of the Module's Call and SMS alert sound mode. The value of the
command is saved after a power cycle.
Command
Syntax
Response/Action
Remarks
Set
+CALM=<call_mode
>,<SMS_mode>
OK
or:
The Set command sets the Call and
SMS alert sound mode.