Fibocom G510 - MRST, Perform Hardware Power down; WRIM, RI Signal Width Setting

G5/G6-Family AT Commands User Manual Page
167
of
243
1 Even
4 No parity (default)
Example:
AT+ICF?
+ICF: 3,4
OK
AT+ICF=?
+ICF: (1-3,7),(0,1,4)
OK
AT+ICF=3,1
OK
10.1.12 +MRST, Perform Hardware power down
The +MRST command enables customer software to perform a hardware power down to the Module unit.
This command provides a software power-off without network logging off.
Command
Syntax
Response/Action
Remarks
Set
+MRST
OK
The Set command performs a graceful hardware
power down to the Module.
Note: The Read and Test commands are not
permitted for the +MRST command.
Example:
AT+MRST
OK
// Result - Module performs a power down
10.1.13 +WRIM, RI signal width setting
In IDLE Mode, Module’s RI pin is High voltage level. When Module receive a SMS or Call, This pin can
output a Low voltage pulse. This command defines the width of pulse can be set.
Command
Syntax
Response/Action
Remarks
Set
+WRIM=<type>,<wi
dth>
OK
or:
Set width