Fibocom G510 - 12.2.2 +CGDCONT, Define PDP Context

G5/G6-Family AT Commands User Manual Page
187
of
243
+CGCLASS: (CC) //Note that CC is a not supported value.
12.2.2+CGDCONT, Define PDP Context
This command specifies the PDP (Packet Data Protocol) context.
Command
Syntax
Response/Action
Remarks
Set
AT+CGDCONT=[<cid>
[,<PDP_type>[,<APN>
[,<PDP_addr>[,<d_co
mp>[,<h_comp>]]]]]]
OK
or:
+CME ERROR: <err>
The Set command specifies the
context identification parameter
values for a PDP context. A
special form of the Set
command, +CGDCONT= <cid>
causes the values for context
number <cid> to become
undefined.
Read
AT+CGDCONT?
+CGDCONT:
<cid>,<PDP_type>,<APN>,
<PDP_addr>,<data_comp>
,<head_comp>[<CR><LF>
+CGDCONT:
<cid>,<PDP_type>,<APN>,
<PDP_addr>,<data_comp>
,<head_comp>
OK
The read command returns the
current settings for each defined
context.
It will be read only “OK” without
any set command.
Test
AT+CGDCONT=?
+CGDCONT: (range of
supported <cid>s),
<PDP_type>, , , (list of
supported <d_comp>s),
(list of supported
<h_comp>s)
OK
The Test command returns the
values supported as a
compound value. If the ME
supports several PDP types,
<PDP_type>, the parameter
value ranges for each
<PDP_type> are returned on a
separate line.
The following table shows the +CGDCONT parameters.
<Parameter>
Description