Fibocom G510 - MJDC Jamming Detection

G5/G6-Family AT Commands User Manual Page
146
of
243
The following table shows the +CA parameters.
<Parameter>
Description
<Cell allocation 1>,<Cell allocation
2>,<Cell allocation 3>
Absolute Radio Frequency Channel Number
Range: [1-124], [128-251], [512-885], [975-1023].
Example:
AT+MCI=1 // Get the current serving and neighbor info.
OK
+MCI: 58,48,-71, ,72,29,-70,522,47,-76,84,24,-77,68,42,-81,88,17,-82,86,42,-85
+CA: 7,12,29,37,41,44,47,58,73
9.1.11 +MJDC Jamming Detection
Detect the jamming.
Command
Syntax
Response/Action
Remarks
Set
+MJDC=<mod
e>
OK
or:
+CME ERROR: <err>
The Set command controls the
presentation of an unsolicited
result code "+MJDC: " and the
result of the Read operation.
Read
+MJDC?
+MJDC:
<mode>[,<jamming>]
OK
The read command returns the
current <mode> parameter value
and detect result.
Only <mode> is 1,the <jamming>
will show .
Test
+MJDC=?
+MJDC: (list of
supported <mode>s)
OK
The Test command returns the
possible <mode>.
The following table shows the +MJDC parameters.
<Parameter>
Description
<mode>
0 don’t detect the jamming
1 detect the jamming