Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
25
of
243
4.1.4 S, Bit Map Registers
This command reads/writes values of the S-registers. The module supports this command for various S
values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command
Syntax
Response/Action
Remarks
Set
ATSn=<value>
OK
or:
+CME ERROR: <err>
The Set command is allowed for
read/write S-registers, and not
allowed for read-only S-registers.
Read
ATSn?
<current value of
S-register n>
OK
or:
+CME ERROR: <err>
Test
The Test command for Sn is not
defined by ITU, and therefore is not
supported by the Module. The G5xx
returns an error.
The following table shows the different S-registers and their associated values.
Sn
Description
Min
Max
Default
S0
Sets/gets number of rings before auto answer.
0
255
0
S3
Sets/gets carriage return code character.
0
127
13
S4
Sets/gets line feed code character.
0
127
10
S5
Sets/gets command line editing character(backspace).
0
127
8
S12
Sets/gets guard time (in units of 50 msec) for the
escape character during ODM connections
0
255
50
Note: S0 (Auto Answer) should work regardless of the DTR HW line state. This is a deviation from the
ITU V. 25-ter standard.
Example:
ATS0?
000
OK

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English