Fibocom G510 - MIPDSETS, Set Size and Timeout for Output Received Data

AT Commands User Manual Page
213
of
243
The following table shows the +MIPRTCP parameters.
<Parameter>
Description
Socket_ID
1,2,3,4 - Number of valid sockets.
Left
Size of received Data still left in protocol stack.
Data
Data string received with 0-F hexadecimal digits. String ends with a
<CR>.
Example:
+MIPRTCP: 3,0,7171
13.1.11+MIPDSETS, Set Size and Timeout for Output Received Data
This command causes the Module to set a max length and time span when send out data to user.
Command
Syntax
Response/Action
Remarks
Set
+MIPDSETS=<So
cket_ID>,<length>
[,<TimeSpan>]
OK
or:
ERROR
+MIPDSETS: <err>
TimeSpan is
defined in
milliseconds.
Read
+MIPDSETS?
+MIPDSETS:
[<Socket_ID>,<Current length
Settings>,< TimeSpan>]
OK
For all ACTIVE sockets.
Test
+MIPDSETS=?
+MIPDSETS: (1-4),(list of
supported <length>s),),(list of
supported <TimeSpan>s)
OK
The following table shows the +MIPDSETS parameters.
<Parameter>
Description
length
Max length when send out data: