Fibocom G510 - CGED, Module Cell Description

G5/G6-Family AT Commands User Manual Page
148
of
243
9.1.13 +CGED, Module Cell Description
This command displays information about the Cellular Network. The information is divided throughout 21
screens, each of them with different parameters data.
Command
Syntax
Response/Action
Remarks
Set
+MCELL=<mode>
, <screen_num>
OK
or:
+CME ERROR:
<err>
The Set command will return “OK” only.
The relevant <screen_info> will return
back with +MCELL format few seconds
later.
Read
+MCELL?
OK
The Read command just returns OK
and does nothing.
Test
+MCELL=?
+MCELL: (list of
supported
<mode>s), (list of
supported
<screen_num>s)
OK
The Test command returns the possible
<mode> & <screen_num> values.
The following table shows the +MCELL parameters.
<Parameter>
Description
<mode>
0 One shot requested.
<screen_num>
The requested screen number - An integer number.
1 Serving Idle Information screen
2 Circuit Switched Serving Cell Information screen
3 Miscellaneous Information screen
4 Uplink Data Transfer screen
5 Downlink Data Transfer screen
6 Neighbor 1 Cell Information screen
7 Neighbor 2 Cell Information screen
8 Neighbor 3 Cell Information screen
9 Neighbor 4 Cell Information screen