Fibocom G510 - Page 192

G5/G6-Family AT Commands User Manual Page
192
of
243
supported<precedence>s),
(list of supported <delay>s),
(list of supported
<reliability>s), (list of
supported <peak>s), (list of
supported <mean>s)
OK
the ME supports several PDP types,
the parameter value ranges for each
PDP type are returned on a separate
line.
The following table shows the +CGQREQ parameters.
<Parameter>
Description
<cid>
A numeric parameter that specifies a particular PDP context definition.
The value is from 1 to 2.
<precedence>
A numeric parameter that specifies the precedence class.
<delay>
A numeric parameter that specifies the delay class.
<reliability>
A numeric parameter that specifies the reliability class.
<peak>
A numeric parameter that specifies the peak throughput class.
<mean>
A numeric parameter that specifies the mean throughput class.
Example:
AT+CGQREQ=?
+CGQREQ: ("IP"),(1-2),(0-4),(0-5),(0-9),(1-18,31)
OK
AT+CGQREQ?
+CGQREQ: 1,2,4,3,9,10
+CGQREQ: 2,2,4,3,9,10
OK
AT+CGQREQ=1,0,,0,0,10
OK
AT+CGQREQ?
+CGQREQ: 1,0,4,0,0,10
+CGQREQ: 2,2,4,3,9,10
OK