"Frequency out
of
range for function",
"Unused error code",
"Selfcalibration data invalid",
"Manual calibration data invalid",
"Store setup error",
"Recall setup, missing waveform",
"Recall setup, incompatible version",
"Trigger gate must
be
on",
"Cal Enable switch must be
in
CAL position",
"Frequency must be 5 5 MHz for trigger
operation",
"Cannot sweep a sequence",
"Trace size must be an even number",
"Trace stnrt must be an even number",
"Trace stop must be an odd number",
"Deleted trace being output, Func Out is now
Sine ",
"Sequence not properly defined"
"Backup RAM contents invalid, RAM has been
re-initialized",
"Cannotgate a sequence",
"Start/Stop frequency
ratio>
0.9",
"Signal name not defined",
"Invalid command for selected noise function",
"Noise calculations, waveform clipped",
"Signal Frequency too low",
"Signal Frequency too high",
Error code
31
ErroT
code 32
ErroT
code 33
Error code 34
ErroT
code 35
Error code 36
ErroT
code 37
ErroT
code 38
ErroT
code 39
Error code
40
ErroT
code
41
ErroT
code
42
Error code 43
ErroT
code 44
ErroT
code 45
ErroT
code
46
Error code 47
Error code 48
ErroT
code 49
ErroT
code 50
Error code 51
Error
code
52
Error code 53
ErroT
code 54
Error
code
61
ErrOI
code
60
ErroT
code
68
Error code 55
Error code 56
Error
code
57
Error
code
58
Error
code
59
Error
code
62
Error code 63
ErroI
code
64
ErroT
code
65
Error
code
66
Error
code
67
"Noise calculations, waveform tao large",
"Bandwidth> lOMHz",
"Function canceled",
"Noise sequence length
tao
long for funètion",
"Pulse delay is too negative",
"Trigger count >524287 for sequence not
a1lowed",
"Selected attenuator causes lower amplitude
and offset",
"Frequency span (carrier/modulation)
tao
high",
"Function not allowed as signal",
"Frequency
tao
high for AM!FM",
"Function setup error",
"Cannot use selected function as signal",
"Internal Execute Error",
"Maximum number
of
waveforms have been
defined",
"Function:
<NAME>
not allowed as signal"
"Pulse <1..10>, <delay,lead,width,trail> slb "greater
or
less
than"
<limit> for
this period range"
"Pulse <1..10>, width too small for lead/trail, must
be
>limit"
"Pulse <1..10>, delay
+ lead +width + trail > period"
"Pulse <1..10>, delay
+ lead + width + trail > period"
E-4 Information/Error Messages
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
