E.3 OISPLAYEO MESSAGES
The following list contains error messages that might occur during front panel operation.
Amplitude/Offset
Selected attenuator causes lower amplitude and offset
AM/FM
Frequency span (carrier/modulation) tao high
Frequency tao high for AMIFM
Bandwidth > lOMHz
StartiStop frequency
ratio>
0.9
Calibration
Cal enable switch must be on CAL to access
c,1l1ihration.
Set
aH
calibration constants to default ?
Procedure stopped! Save new cal
data?
Procedure completed! Save new cal data ?
Unable
ta
write to EEPROM
Calibration data version invalid
OSO Upload
DSO upload requires that the IEEE-488 option be installed.
Cannat perform DSO upload while in remote.
General
Data out
of
Range;
min
value: x, max value: y
Unable to access application hardware
Mode
Cannat
use sweep mode while running a sequence
Cannat sweep pulse functions
Cannat sweep noise functions
Cannat use gated
mode
while running a sequence
Cannat sweep AM function
Cannat sweep FM function
Noise
Noise calculations, waveform
tao
large
Pulses / Pulse Trains
Pulse delay is tao negative
Pulse <1..10>, <delay,lead,width,trai1> slb "greater
or
less than <limit> for this
period range"
Pulse <1..10>, width too smal1 for leadltrail, must
be
>limit
Pulse <1..10>, delay
+lead + width +trail > period
Pulse <1..10>, delay + lead + width + trail > period
Remote Setup
IEEE-488 option not installed
Parameter cannat be changed while remote. Go
ta
local or change Keys setting
on
Remote screen.
Information/ErrorMessages
E-S
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
