Step 1 Initial Setup and Power On
Connect the Model 395 to a power source see paragraph 2.6 Initial Turn-On. Push the
POWER switch in. The Model 395 displays its start-up screen.
POWER
( )
Wavetek
Model395
(for assistance,
press HELP)
STEP 2. ENABLING THE MAIN OUT
To output the signal generated by the Model 395, you mustenable the output by pressing
the
MAIN
OUT
key. A lit indicator lights indicates the output is on.
ON
If
a scope is connected
ta
the Main Out, you will sec a waveform on the scope screen.
Step 3 Synchronizing the Scope and
Model395
To
synchronize the scope signal with the
Madel
395, press the
SYNC
OUT
key
ta
display the Sync Output Setup screen:
SYNCOUf
( )
F2
( )
SYNCOUT
SETUP
<>
output: off
<>
mode:
auto
<>
src: waveform sync
Enable the Sync Out signal by pressing
F2
"output" until "output: on" appears. The Sync
Out
indicator lights.
Introduction
To
The
Model395 3-7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
