Foundry Configuration Guide for the FESX, FSX, and FWSX
22 - 24 © Foundry Networks, Inc. December 2005
Displaying Detailed Information for an Individual VRID
You can display information about the settings configured for a specified VRRP Virtual Router ID (VRID). For
example, to display information about VRID 1:
backup router <ip-addr> expires in
<time>
The IP addresses of Backups that have advertised themselves to this
Master by sending Hello messages.
The <time> value indicates how long before the Backup expires. A
Backup expires if you disable the advertise backup option on the
Backup or the Backup becomes unavailable. Otherwise, the Backup’s
next Hello message arrives before the Backup expires. The Hello
message resets the expiration timer.
An expired Backup does not necessarily affect the Master. However, if
you have not disabled the advertise backup option on the Backup,
then the expiration may indicate a problem with the Backup.
Note: This field applies only when Hello messages are enabled on
the Backups (using the advertise backup option).
next hello sent in <time> How long until the Backup sends its next Hello message.
Note: This field applies only when this Layer 3 Switch is the Master
and the Backup is configured to send Hello messages (the advertise
backup option is enabled).
master router <ip-addr> expires in
<time>
The IP address of the Master and the amount of time until the
Master’s dead interval expires. If the Backup does not receive a Hello
message from the Master by the time the interval expires, either the IP
address listed for the Master will change to the IP address of the new
Master, or this Layer 3 Switch itself will become the Master.
Note: This field applies only when this Layer 3 Switch is a Backup.
track port The interfaces that the VRID’s interface is tracking. If the link for a
tracked interface goes down, the VRRP or VRRPE priority of the VRID
interface is changed, causing the devices to renegotiate for Master.
Note: This field is displayed only if track interfaces are configured for
this VRID.
Table 22.4: CLI Display of VRRP or VRRPE Detailed Information (Continued)
This Field... Displays...
FastIron SuperX Router(config)# show ip vrrp vrid 1
VRID 1
Interface ethernet 3/11
state initialize
administrative-status disabled
mode non-owner(backup)incomplete
priority 12
current priority 12
track-priority 22
hello-interval 1 sec
dead-interval 0 sec
current dead-interval 3.900 sec
preempt-mode true
advertise backup: disabled
To Next Page
Loading...
Need help?
General
