Using Syslog
December 2005 © Foundry Networks, Inc. A - 15
Informational DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID is
user defined and cannot be used
The port was assigned a MAC address filter
ID that had been dynamically created by
another user.
Informational DOT1X : port <portnum> - mac <mac
address> is unauthorized because system
resource is not enough or the invalid
information to set the dynamic assigned IP
ACLs or MAC address filters
802.1X authentication failed for the Client
with the specified <mac address> on the
specified <portnum> either due to insufficient
system resources on the device, or due to
invalid IP ACL or MAC address filter
information returned by the RADIUS server.
Informational DOT1X : port <portnum> - mac <mac
address> Port is already bound with MAC
filter
The RADIUS server returned a MAC
address filter, but a MAC address filter had
already been applied to the port.
Informational DOT1X : port <portnum> - mac <mac
address> This device doesn't support ACL
with MAC Filtering on the same port
The RADIUS server returned a MAC
address filter while an IP ACL was applied to
the port, or returned an IP ACL while a MAC
address filter was applied to the port.
Informational DOT1X Port <portnum> is unauthorized
because system resource is not enough or
the invalid information to set the dynamic
assigned IP ACLs or MAC address filters
802.1X authentication could not take place
on the port. This happened because strict
security mode was enabled and one of the
following occurred:
• Insufficient system resources were
available on the device to apply an IP
ACL or MAC address filter to the port
• Invalid information was received from
the RADIUS server (for example, the
Filter-ID attribute did not refer to an
existing IP ACL or MAC address filter)
Informational DOT1X: Port <portnum> currently used vlan-
id changes to <vlan-id> due to dot1x-
RADIUS vlan assignment
A user has completed 802.1X authentication.
The profile received from the RADIUS server
specifies a VLAN ID for the user. The port to
which the user is connected has been moved
to the VLAN indicated by <vlan-id>.
Informational DOT1X: Port <portnum> currently used vlan-
id is set back to port default vlan-id <vlan-id>
The user connected to <portnum> has
disconnected, causing the port to be moved
back into its default VLAN, <vlan-id>.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
authorized
The status of the interface’s controlled port
has changed from unauthorized to
authorized.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
unauthorized
The status of the interface’s controlled port
has changed from authorized to
unauthorized.
Table A.3: Foundry Syslog Messages (Continued)
Message Level Message Explanation