Fuji Xerox Versant 80 Press

Machine Components
59
Product Overview
2
 C3 Finisher (optional), C3 Finisher with Booklet Maker (optional)
* : Available when the C3 Finisher with Booklet Maker is installed
Note •In this guide, “C3 Finisher” and "C3 Finisher with Booklet Maker" are referred to as "finisher".
89
7
1
5
2
6
4
3
No. Component Function
1 Transport Unit V1 front door Open this door to clear paper jams.
2 Hole punch waste container Collects punch scraps from the puncher. Remove this container when
discarding the punch scraps.
3 Output tray Outputs are delivered here.
4 Finisher tray Outputs are delivered here.
5 Staple cartridge Staples are stored in this cartridge. Pull out this cartridge to replace staples
or clear staple jams.
6
Booklet tray
*
Bound booklets are delivered here.
7 Finisher front door Open this door to clear paper or staple jams, replace staples, or discard
punch scraps.
8
Booklet unit
*
This unit is for folding outputs in half and stapling the folded outputs.
9
Booklet staple cartridges
*
Two staple cartridges for booklet creation. Take out the cartridges when
clearing staple jams, or when replacing them with new ones.