Stapler Faults
905
Problem Solving
22
4 After removing the staple cartridge, check the
inside of the finisher for any remaining staples.
5 Push the metal part of the staple cartridge
upward.
6 Remove the jammed staples (1), and return the
metal part pushed upward in step 5 to its
original position (2).
7 With grasping the orange lever of the staple
cartridge, push the staple cartridge into its
original position until it clicks into place.
8 Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine remains
paused.
If you cannot remove jammed staples even after you perform the above procedure, contact
our Customer Support Center.
When the Finisher D4, Finisher D4 with Booklet, or Finisher D5 is installed
The following describes how to clear staple jams in the Finisher D4 with Booklet as an
example. The procedure is the same as for the Finisher D4 and the Finisher D5.
For remedies if the staple cartridge happened to come off the holder, refer to "Re-inserting
the Staple Cartridge into the Cartridge Unit" (P.911).
Be careful in removing jammed staples.
To Next Page
Loading...
