Fujitsu PRIMERGY BX900 - Page 433

© 2011 Fujitsu Technology Solutions
431
10.4.5.7 vtp mode
This command uses to set VTP device mode. There are three modes you can configure, Client, Server,
and Transparent.
Syntax
vtp mode { client | server | transparent }
no vtp mode
no - This command resets the VTP mode to default value.
Default Setting
Server
Command Mode
Global Config
10.4.5.8 vtp password
This command uses to configure the VTP administrative domain password.
Syntax
vtp password <password>
no vtp password
<password> - Configures VTP administrative domain password.(Max. length 64 bytes)
no - This command resets the VTP domain password to default value.
Default Setting
None
Command Mode
Global Config