Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps; Removing 3.5-Inch HDD out of; Inch Dummy Cover; Required Tools

100 Upgrade and Maintenance Manual MX130 S2
HDDs and accessible drives
Ê Connect cables to the HDD.
1 Power cable connector P2 (see "Power cable T26139-Y4012-V211"
on page 239)
2 SATA cable T26139-Y4028-V153
7.7.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in section "Closing the front cage" on
page 53.
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 67.
7.8 Removing 3.5-inch HDD out of 5.25-inch
dummy cover
7.8.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD
– Phillips PH2 / (+) No. 2 screw driver
7.8.2 Preliminary steps
Before removing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Open the front cage as described in section "Opening the front cage" on
page 52.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.