Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps

MX130 S2 Upgrade and Maintenance Manual 141
HDDs and accessible drives
Figure 78: Removing the ODD cover
Ê Press the ODD cover out from inside to outside of the server cover.
Ê Remove the ODD cover
7.19.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in section "Closing the front cage" on
page 53.
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 66.