Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Install HDD in 5.25-inch ODD;HDD Bracket

MX130 S2 Upgrade and Maintenance Manual 103
HDDs and accessible drives
V CAUTION!
Always replace dummy modules into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
7.8.4 Concluding steps
Perform the following procedures to complete the task:
Ê Install the 5.25-inch dummy cover as described in section "Installing 5.25-
inch dummy cover" on page 110.
Ê Follow all procedures described in section "Closing the server" on page 54.
7.9 Installing additional 3.5-inch HDD in 5.25-
inch ODD/HDD bracket
7.9.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD
– Phillips PH2 / (+) No. 2 screw driver
7.9.2 Preliminary steps
Before installing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.
Ê Remove the 5.25-inch dummy cover as described in section "Removing a
5.25-inch dummy cover" on page 113.