202 Upgrade and Maintenance Manual MX130 S2
System board and components
Ê Carefully pry the depleted CMOS battery out of its socket.
Ê Remove the CMOS battery (2).
I Do not throw the CMOS battery into the trash can. Lithium batteries
must be disposed of in accordance with local regulations concerning
special waste.
12.1.4 Installing the CMOS battery
Figure 126: Installing the CMOS battery
Ê At a slight angle, fit the new CMOS battery into its socket as shown (1).
V CAUTION!
Ensure to insert the CMOS battery with the positive pole (label side)
facing up.
The lithium battery must be replaced with an identical battery or a
battery type recommended by the manufacturer (CR2032).
To Next Page
Loading...
