Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps

144 Upgrade and Maintenance Manual MX130 S2
HDDs and accessible drives
Figure 80: Removing the ODD
Ê Press the green locking (1) and pull the ODD out of its bay (2).
Ê Install a new ODD in this bay.
7.20.4 Concluding steps
Perform the following procedures to complete the task:
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 66.
/
0