170 Upgrade and Maintenance Manual MX130 S2
Expansion cards
9.2.3.4 Connecting cable of the eSATA cable to connector
Figure 104: Connecting the eSATA cable
Ê Connect the end of eSATA cable to the system board connector SATA6.
Ê Fold the cable carefully as shown in the picture.
9.2.3.5 Concluding steps
Perform the following procedures to complete the task:
Ê Follow all procedures described in section "Closing the server" on page 54.
9.2.4 Removing eSATA cable
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
To Next Page
Loading...
