Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Install HDD in 5.25-inch Dummy Cover

MX130 S2 Upgrade and Maintenance Manual 97
HDDs and accessible drives
7.7 Installing additional 3.5-inch HDD in 5.25-
inch dummy cover
7.7.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD
– Phillips PH2 / (+) No. 2 screw driver
7.7.2 Preliminary steps
Before installing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.
Ê Remove the 5.25-inch dummy cover as described in section "Removing a
5.25-inch dummy cover" on page 113.