Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps; Removing 3.5-Inch HDD out of 5.25-Inch ODD;HDD Bracket; Required Tools

106 Upgrade and Maintenance Manual MX130 S2
HDDs and accessible drives
Ê Connect cables to the HDD.
1 Power cable connector P2 (see "Power cable T26139-Y4012-V211"
on page 239)
2 SATA cable T26139-Y4028-V153
Ê Connect cables to the ODD.
3 Power cable connector P4 (see "Power cable T26139-Y4012-V211"
on page 239)
4 SATA cable T26139-Y4028-V201
7.9.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in section "Closing the front cage" on
page 53.
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 67.
7.10 Removing 3.5-inch HDD out of 5.25-inch
ODD/HDD bracket
7.10.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD
– Phillips PH2 / (+) No. 2 screw driver