Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Removing Slimline ODD out of 5.25-Inch ODD;HDD Bracket; Required Tools; Preliminary Steps

MX130 S2 Upgrade and Maintenance Manual 125
HDDs and accessible drives
7.16 Removing slimline ODD out of 5.25-inch
ODD/HDD bracket
7.16.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing a slimline ODD
– EMEA: Torx Plus Size 6
– Japan: Philips (+) No.00 screw driver
7.16.2 Preliminary steps
Before removing a slimline ODD, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 60.
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Open the front cage as described in section "Opening the front cage" on
page 52.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.