214 Upgrade and Maintenance Manual MX130 S2
System board and components
● Replacing the system board:
– Phillips PH2 / (+) No. 2 screw driver
● Replacing the system board:
– Magnifying glass (for inspecting socket cover springs)
If a TPM module is installed:
– Bit screw driver
– TPM bit insert*
– thin slotted screw driver (
2 x 0.4 mm)*
*For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)
12.3.2 Preliminary steps
Before replacing the system board, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Shut down the server as described in section "Shutting down the server" on
page 48.
Ê Disconnect all external cables.
Ê Bring the server to its horizontal position.
Ê Remove the server cover as described in section "Removing the server
cover" on page 51.
Ê Fold open the front cage.
To Next Page
Loading...
