Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Removing ODD out of 5.25-Inch Chassis Bay; Required Tools; Preliminary Steps

118 Upgrade and Maintenance Manual MX130 S2
HDDs and accessible drives
7.14 Removing ODD out of 5.25-inch chassis
bay
7.14.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing an ODD: tool-less
7.14.2 Preliminary steps
Before removing an ODD, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 60.
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Open the front cage as described in section "Opening the front cage" on
page 52.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.