MX130 S2 Upgrade and Maintenance Manual 179
10 Main memory
Safety notes
V CAUTION!
● Do not install unsupported third party memory modules. For further
information on supported memory modules, refer to section "Basic
procedure" on page 180.
● Memory modules remain hot after shutdown. Wait for components to
cool down before installing or removing memory modules to prevent
burns.
● Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
● Pressing out the securing clips on the memory module connector will
eject the installed memory module. To prevent damage and injuries
eject memory modules carefully without applying excessive force.
● For further information, please refer to chapter "Important
information" on page 31.
In this chapter
● "Memory sequence" on page 180
● "Operation modes" on page 181
● "Installing memory modules" on page 182
● "Removing memory modules" on page 184
To Next Page
Loading...
