70 Upgrade and Maintenance Manual MX130 S2
Power supply
6.1 Standard PSU
6.1.1 Replacing the standard PSU
6.1.1.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the PSU:
– Phillips PH2 / (+) No. 2 screw driver
6.1.1.2 Preliminary steps
Before replacing the standard PSU, perform the following steps:
I You are advised to perform this routine with the server in a horizontal
position.
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Follow all procedures described in section "Opening the server" on page 48.
Field Replaceable Units (FRU)
Average task duration: 10 minutes
To Next Page
Loading...
