Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Install 3.5-inch HDD

MX130 S2 Upgrade and Maintenance Manual 83
HDDs and accessible drives
7.3 Installing 3.5-inch HDD in HDD1 / HDD2
chassis bay
7.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD: tool-less
7.3.2 Preliminary steps
Before installing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Open the front cage as described in section "Opening the front cage" on
page 52.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes